Customer Support
+34 972 661 661
Price (inc. VAT)
€3,925.00
€5,375.00
Offer
-27%
Price (inc. VAT)
€29.95
€62.00
Offer
-52%
Price (inc. VAT)
€89.00
€249.00
Offer
-64%
Price (inc. VAT)
€25.00
€57.00
Offer
-56%
Price (inc. VAT)
€125.00
€195.00
Offer
-36%
Price (inc. VAT)
€368.00
€498.00
Offer
-26%
Price (inc. VAT)
€49.00
€65.00
Offer
-25%
Price (inc. VAT)
€69.95
€75.00
Offer
-7%
Price (inc. VAT)
€149.00
€199.00
Offer
-25%
Price (inc. VAT)
€59.00
€101.00
Offer
-42%

Ikelite 4401.3 (3rd Gen)

Manufacturer: Ikelite
Availability: Usually ships in 1-2 weeks
Share

Fiber Optic Converter 4401.3 for DS Strobes. Converts the electrical bulkhead of any Ikelite DS strobe into a fiber optic port.

Price (exc. VAT) €103.31

Price (inc. VAT) €125.00

Shipping cost from €14.00
Calculate shipping cost

Add to Cart

Fiber Optic Converter 4401.3 for DS Strobes. Converts the electrical bulkhead of any Ikelite DS strobe into a fiber optic port.

Updates

This 3rd Generation of the Fiber Optic Converter features a hard anodized aluminum plug connection which reduces weight without sacrificing durability. It is recommended for use with any Ikelite strobe produced September 2018 or later with a hard anodized aluminum bulkhead. 

Like the 2nd Generation model, this Fiber Optic Converter features heightened sensitivity for use with SEA&SEA or Nauticam housings with internal electrical-to-optical flash triggering devices. These devices translate the camera's electrical signals into a series of LED flashes which are much less bright than a traditional built-in camera flash. The Fiber Optic Converter is also compatible with any system where the camera's built-in flash can be seen by a fiber optic cord.

Attachment and Use

The Converter simply attaches to the strobe's electrical bulkhead in place of a sync cord connector. The enlarged slave window provides approximately 90 degrees field of view for remote triggering. 

The Fiber Optic Converter automatically configures itself for compatibility with both pre-flash and non pre-flash camera modes. No setting of small switches or confusion over number of pre-flashes. Simply turn on your strobe and take one picture to configure. This adapter is a manual exposure (non-TTL) trigger only. The strobe's output may be adjusted using the manual power settings built into the strobe (varies by model). 

An individual Fiber Optic Converter and compatible cord is needed for each strobe. Use of two strobes requires two Fiber Optic Converters.

This converter attaches to an Ikelite DS strobe. It is not intended to be attached to a housing and will provide no functionality if attached to an Ikelite bulkhead in a housing.

Alternatives

There are two shooting scenarios where the High Sensitivity Optical Slave Converter # 4405 would be a better option:

  • If you're shooting a DSLR or mirrorless camera with Nauticam fiber optic converter and want to shoot at a higher frame rate (4 FPS or faster).
  • If your primary purpose is to trigger your strobes remotely at a distance from the housing without a fiber optic cable in between.

Strobe Compatibility

  • Ikelite DS50, DS51
  • Ikelite DS125
  • Ikelite DS160, DS161
  • 1.1 diameter x 2.7 in (28 x 69 mm)
  • Weighs 1.6 oz (45 g)
  • Depth rating 300 ft (90 m)
  • Fiber Optic Converter
  • Connector protector # 0301.12
IKELITE provides a limited warranty to the original purchaser against all defects in original workmanship and material under normal SCUBA use and service as outlined in the owner's manual for 2 years from the date of purchase, with the following exceptions:
  • This warranty does not cover commercial or rental use.
  • Should your equipment prove to be defective for any reason (other than those listed in the limitations section below) it will be repaired or replaced at IKELITE´s discretion, free of charge, excluding shipping and handling charges.
  • Repairs made under this warranty will not extend the warranty period
  • This warranty is non-transferable and applies to the original purchaser only.
  • All correspondence concerning this warranty must be accompanied by a copy of the original sales receipt.
  • Any flood or damage, for any reason, that is caused from flooding an O-ring sealed or water tight area will not be covered under warranty. All O-ring sealed products undergo extensive factory pressure testing before being shipped and delivered and are therefore guaranteed to be sealed and functioning when shipped from the factory.
  • IKELITE nor ADITECH will not be liable for any loss, damages, or expenses including incidental or consequential damages directly or indirectly arising from the sale or use of the product.
  • IKELITE accepts no liability for any loss of captured images or the inability to capture images even if it is due to the malfunctioning or leakage of the housing.
  • All paint finishing, cosmetic discoloration of surfaces, powder coating, or material stitching that is chipped, damaged, or unthreaded through customer use is not covered in the warranty.
  • IKELITE does not warranty any product for aesthetic finishes. Issues with surface finish that do not affect function of the product are not covered under warranty.
  • This warranty does not apply and may be rendered completely void in the event of accidental damage, abuse, overcharging of battery, flooding due to neglect, tampering, lack of care and maintenance, improper storage, or unauthorized service.
  • This warranty specifically excludes lenses, cords, connectors, O-rings, or other conditions resulting from misuse and negligence.
  • This warranty becomes void if the housing components are damaged by anything other than normal recreational diving use.
  • Modifications or repair by anyone other than an authorized IKELITE Dealer or ADITECH Service Department will void the warranty.
  • By purchasing this product you agree and understand that in no event will IKELITE, its distributors or retailers, be held liable for any personal injuries resulting from its operation, or any other damage whether direct, indirect, incidental or consequential, even if IKELITE or ADITECH is advised of such damages.

Do you have any doubts?